Auto Repair in Camarillo

You may live in a region where roads become pockmarked with craters known better as potholes.  They're caused by moisture seeping through a compromised road surface that can freeze, expand and literally punch holes in the road.  And when your vehicle hits one of those holes that's big enough, the impact can flatten a tire, bend a wheel or tear apart a suspension component. 

To minimize pothole damage, leave enough room between you and the vehicle in front of you so you can see the road surface and any upcoming potholes.  That way you'll have time to slow down and steer around them.  Also, if you see what looks like a puddle of water, it may be hiding a pothole underneath, so treat it as if was a pothole.

If you keep your tires inflated to the manufacturer's specifications, they're more likely to withstand hard impacts.  And the slower you're going when you hit a pothole, the less likely you are to break something.   But if you do find you've hit a pothole pretty hard, here are some signs to watch out that could signal damage.

• Your vehicle pulls to one side
• The steering wheel shakes
• You hear noises or clunks coming from your suspension
• Your steering wheel is not centered when you are going straight

These are all symptoms you should have checked at your vehicle repair facility as soon as you can. The longer you wait, the more damage you may be doing.

You also may find after hitting a pothole hard that the tire on that wheel is flat. Try not to drive any more on that tire since you could do a lot more damage to the tire and/or wheel. A call to roadside assistance may save you money in the long run by limiting the damage to what's already done.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

You know how heavy your engine and transmission are, so you can imagine how tough the parts that hold them onto your vehicle's sub-frame must be.  Not only must they support the weight, they also have to isolate vibrations and noise from the passenger cabin.  Pretty tall order, wouldn't you say?

The parts that face that task daily are called the motor mounts, or engine mounts.  They are usually made of rubber with steel brackets.  Others contain a liquid for vibration and sound isolation. 

Most vehicles have three or four motor mounts, and while rubber or hydraulic liquids do a good job of damping the vibrations from the engine, they also have their limitations.  The problem with rubber is that it gets old and brittle.  Plus, if there's an oil leak anywhere in your engine and oil gets on the rubber motor mounts, rubber will deteriorate even more quickly.  As for the liquid motor mounts, they can develop leaks and stop working. 

Here are signs a motor mount is going bad.  You may hear a loud clunking or banging sound under the hood.  That means the weight of the engine is shifting around enough to bang against other metal parts.  You may feel bad vibrations, and the engine may feel like it's moving around in a strange way.

When things get to that point, your vehicle can be damaged from that heavy engine knocking against things, and its time to replace one or more motor mounts.  Schedule a visit to your vehicle service facility. There, a technician will assess your motor mounts; if one bad one is found, it's not unusual that others are likely to fail soon and should be replaced before they do.

Because all vehicles are configured differently, some motor mounts are easily replaced.  But others can be much trickier, take a lot longer and therefore are more expensive to replace. 

It's important for your engine's health to make sure motor mounts are sound and solid.  You will maintain that quiet, vibration-free ride and could save your engine and transmission from major wear and tear.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

The other day, a driver was trying to open his vehicle's hood so he could add some windshield washer fluid.  But when he pulled the hood release inside the car, nothing happened. 

Usually, opening any hood is a 2-step process.  You pull the hood release (which is usually a handle under the dashboard to the left of the steering column) and listen for the hood to pop up slightly. (It doesn't open all the way because it has a safety latch to prevent you from accidentally opening it up while you're driving.) Then, you get out and find the latch, usually through the grille near the hood.  There's a little handle on it which you push, slide or pull (there are a few different types) at which point the hood can be opened up all the way. 

But in this driver's case, the hood would not release at all when he pulled the handle inside.  Not knowing what to do, he called his service advisor, who told him to bring it over.  The reason? A hood with a broken latch could be a safety hazard since it is possible it's not securely closed. And in this condition, it's possible for the hood to suddenly release while you are driving, obscuring your view of the road. 

Latch issues can be caused by many things, perhaps a broken cable between the hood release and the latch.  It's possible that cable just detached or frayed after being opened so many times.  If a hood release cable isn't kept lubricated, it can corrode and just lock up.

In this driver's case, the cable had corroded and broken, so it had to be replaced.  Unfortunately, many times you won't know you have a problem with your hood latch until one time you pull it and it breaks without warning.  When your vehicle is in for routine maintenance like an oil change, a technician will often keep an eye out for signs that your hood latch needs attention so you don't get "locked" out of your engine compartment.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

Engines required a lot more maintenance in earlier times.  You'd have to have your spark plugs, wires, rotors, caps, distributor points, fuel and air filters changed periodically.  There were mechanical adjustments of a vehicle's timing, dwell, spark gap and idle mixture, too. Unless you like to tinker with old cars, a lot of those terms won't mean much to you. 

That service was called a "tune up" back then, and you can see why.  But now, computers have reduced the number of maintenance items, and a tune up is a whole lot different than it used to be.  In fact, in some vehicle service facilities, that term is also a thing of the past. 

A tune up of today would more accurately be called simply periodic maintenance. Now, most vehicles still have spark plugs and wires, fuel filters, air filters and PCV valves, and they should be inspected tested and/or replaced at regular intervals.  Your vehicle's manufacturer has made recommendations on how often that should be. But it depends on your driving habits. Do you regularly tow a trailer? Do you drive on dusty roads often? Are you driving mostly stop and go in the city?  Depending on your answers, to those maintenance intervals might have to be more frequent.

Your service advisor will likely remind you about those "must check" items such as spark plugs and wires, air filter and oxygen sensor.  And now that the old-fashioned tune ups don't require you to take your vehicle in for maintenance as often, you can get the same benefit from scheduled oil changes or tire rotations.  When your vehicle is in for those, a technician can keep an eye on your other systems (fuel, emissions, ignition) to make sure they are operating correctly.

One thing to remember.  When you take your vehicle in for regular service or a specific issue, don't ever hesitate to ask you service advisor to explain what's being done and why.  Hey, "In Sync" may have been a boy band of an earlier era, but it's always good for you and your service advisor to be "in sync" when it comes to what maintenance is good for your vehicle.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com