Auto Repair in Camarillo

It's no fun when your vehicle just doesn't run the way it used to.   You may notice (especially in cold weather) the engine won't start easily or when it does start, it doesn't run smoothly. It may not have much power at all. You also may have had to stop at the gas station more often, a sign your fuel economy isn't what it used to be. 

There could be a few different things that cause those symptoms, but one culprit could be a bad ignition coil. The coil takes the voltage from your battery and multiplies it before that power is sent over to a spark plug. That allows the plug to fire off a good jolt of electricity that ignites the fuel in your cylinder and powers the engine. 

There's usually one ignition coil for each cylinder (or sometimes for a pair of cylinders). If only one of them is not pushing out enough electricity, it can cause big trouble with your engine performance.  Other signs of a bad ignition coil include engine backfire, an oil leak and your Check Engine light coming on.   When that light comes on and you have some of those other signs, you need to have your repair facility check things out fairly soon because you may be damaging your engine and wind up with a far more expensive repair.

A technician will check for a computer code to pinpoint which cylinder is having the problem.  Using other diagnostics, the technician can rule out other components that might be causing the engine to misfire.  Ignition coils usually last 100,000 miles/160,000 km, but other engine conditions can cause them to fail before then. 

Your service advisor may suggest getting all your coils replaced even though only one is malfunctioning. That's probably a good idea in a higher mileage vehicle since the other coils may be close to failure, too. It's also wise to do that if your vehicle's coils are located in a hard-to-reach spot so you likely won't have to spend the money for that labor again when another one fails.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

Today's vehicles have some pretty amazing technology in them, including a computerized braking system we all pretty much take for granted these days.  Antilock brake systems (ABS) have been around for years but they help drivers stop in much shorter distances reliably than ever before.  When you see your ABS warning light come on, it's important to find out what's causing the problem. It's a safety issue.

Often the problem when the ABS light comes on is a faulty wheel speed sensor.  (In some cases the traction control light will also come on, perhaps because of a non-working wheel speed sensor.) Your vehicle uses the speed sensors to measure the rotational speed at each wheel. That sensor sends the speed data to a computer that can then adjust braking power and prevent your wheels from locking up. 

If any of the wheel speed sensors isn't working right, the ABS warning light will go on and the vehicle's computer will turn off the antilock brake system.  You'll still have working brakes, but you will lose the functionality of that computerized system.

When your vehicle warns you the ABS has a non-working sensor, you can have a technician check to see what's going on. It could be one of the sensors is dirty and a cleaning will solve the problem.  But it also could be that one or more sensors needs to be replaced. 

A technician will use computerized diagnostic equipment to determine what and where the problem is, replace any bad parts and then check to make sure the system is fully operational. 

Antilock brakes and traction control are significant technologies that help prevent your vehicle from slipping on less-than-perfect road surfaces, especially useful during wintery weather.  Make sure they're helping you drive the way they designed to.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

Let's say you live in a cold climate where the snowy, icy weather challenges you to clear the salt and debris tossed up on your windshield.  You push your windshield washer switch expecting a good stream of fluid so the blades can wipe the glass clean. Yet nothing comes out.  Nada, zip.  What's going on? You know you filled up the windshield washer reservoir within the last week or so. 

Well, there could be a few things causing your windshield washing system to fail.  One culprit? The hoses that are supposed to carry that fluid from the washer pump to the spray nozzles may be frozen, or maybe they're cracked and leaking. It could be the nozzles themselves are stopped up, either iced up or jammed full of debris.  Your windshield wiper/washer switch could be worn out or the electrical system may not be conducting power to the washer pump. 

It's important that this system work properly, especially on days when the sun may be in front of you and your windshield is covered with a cloudy, icy mess.  Seeing what's going on in front of you may be like trying to peer through frosted glass, and that's not a safe situation for you or the drivers around you. You need to have this checked out by a technician as soon as you can.

Let's say the technician discovers it's not any of those components.  Turns out it's the electric windshield washer pump itself that's failed. After replacing it, everything is working fine, and you can see again.  As so often is the case with today's complex vehicles, figuring out the root cause of a problem can be tricky.  Rely on your vehicle service facility since they have the know how and diagnostic equipment to make sure your view of the road will always be crystal clear.

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

Winter is one of the hardest times to keep your vehicle clean. But did you know neglecting to wash your vehicle in winter could cost you a significant amount of money in the long run? Here's why.

Many areas deal with snow and ice in the winter, and the salt and sand that are used to keep the road surfaces from being slick are also super corrosive to a vehicle's metal body and undercarriage.  That includes all the parts underneath that can be splashed with brine, saltwater and other road debris.  Winter is also tough on vehicles where there isn’t snow, sometimes from ocean salt or winter's extra humidity and rain. 

If you have any breaks in your vehicle's paint, whether it be from a little fender bender or a stone chip, that corrosive winter moisture can get through those cracks and start eating away at the metal underneath. 

If you can, you should get any dents or damage fixed as soon as possible so your vehicle has a protective layer of paint between road chemicals and the metal.  You may want to wait until the warmer weather, but while you're waiting, the damage is getting worse.  If you're not sure of a reputable body repair shop, check with the service advisor where you have mechanical work done.  They're usually knowledgeable about who is good and not so good. 

You also may be tempted to skip the car wash during the winter since your vehicle is just going to get dirty fast anyway.  You may want to reconsider.  Many winter road treatments now use brine that gets in every nook and cranny of your vehicle.  It's wise to clean that off regularly during the winter, and many washing facilities include a spray underneath that gets rid of that salt.  Your vehicle repair facility may even have its own car wash, a nice bonus when you take your vehicle in for repair or regular maintenance. 

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com