Monthly Archives: August 2021

Breathe New Life into Your Engine (MAF sensor replacement)

If you’ve noticed your vehicle is hard to start, stalling, or has lost power, the culprit may be a part with an odd name: the MAF sensor.  You may have never even heard of a MAF sensor, but it’s important that it be working correctly, or you may be experiencing some fairly significant engine issues.

All vehicles bring in air and direct it through an air filter before it goes into your engine, where it mixes with fuel to provide power to get you going. There’s a tube-like device with a sensor inside it that measures how much of that mass of air is passing through. That’s why it’s called a mass air flow sensor, or MAF sensor.  If the MAF sensor isn’t working right, the engine’s computer can’t figure out the right amount of fuel to mix with it, and your engine may hesitate or stall.  Sometimes this will cause your Check Engine Light to come on, and any time it does that, make sure you have your vehicle checked by a professional, so you’ll know what’s going on.

When you take your vehicle into your service facility, a technician will thoroughly check the system to see just where the problems are.  If your air filter is dirty, your MAF sensor may get dirty too, which might be causing the problems.  You may find your fuel economy isn’t what it used to be either.

There are other things that can cause the same symptoms, too, such as a leak in a vacuum hose. It’s also possible that the electrical connector between the MAF sensor and the engine has broken. 

The technician can use electronic diagnostic equipment to help pinpoint the exact problem or problems, replace worn parts, and test drive your vehicle to make sure it’s working correctly.

It’s also a good idea to make sure your air filter is changed regularly. A dirty air filter can contribute to a MAF sensor failure. One of the big benefits of having your vehicle regularly maintained at one facility, is they know your vehicle. So, they keep track of which of your vehicle’s parts should be periodically replaced before problems develop. 

If you keep clean air heading into your engine, it can help your engine work efficiently, and with the power it was engineered to deliver. Isn’t that a breath of fresh air?

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

I Had No Idea! (Four Things You Didn't Know About Vehicles)

Bet you didn't know:

Some of the earliest rearview mirrors were marketed as "Cop Spotters" so drivers would know when police were following them. Who wants a ticket, anyway? According to eBay Motors, Elmer Berger first patented a rearview mirror that was mounted on the front fenders, on the spare tire secured to the side of the car of at the top of the driver's door frame. 

About 80 percent of your vehicle is recyclable. So says The Balance. That means four-fifths of most vehicles can be recycled.  Much of that recycling is done by automotive aftermarket recyclers.  Between the U.S and Canada, they reclaim enough steel to produce 13 million new vehicles.

The man who invented the first modern cruise control couldn't even drive a car because he was blind! His name, says Smithsonian.com, was Ralph Teetor.  Blinded at a young age by a knife accident, Teetor was inspired to create a speed control by a couple of things.  One, the U.S. imposed a mandatory 35 mph/55 kph during World War II to conserve fuel and tire rubber, and Teetor wanted drivers to go a safe and steady speed.  Plus, a chauffeur who drove him around used to randomly slow down and speed up which irritated Teetor.  So he invented a speed control to encourage drivers to drive at a more constant and safer speed.

The first grooved tires were invented in 1904 by Continental.  But that was a big improvement over the very first "tires" which were actually metal hoops that made riding in the first cars a pretty rough experience.  The first rubber tires were solid rubber, not inflatable like today's tires.  Things have come a long way.  Modern tires are made with sophisticated rubber compounds that can deal with heat and cold.  Plus their tread patterns help drivers get better traction on wet roads when it storms.  Still, it's important to make sure yours have enough tread and are properly inflated for maximum safety and performance.

Quite frankly, there's a lot we don't understand about the vehicles we drive.  They're much more complicated than the old horse and buggy that preceded  them.  Leave your vehicle's maintenance and service to highly trained technicians who DO understand how to maintain, diagnose and repair today's modern, sophisticated vehicles. 

Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

A Turn for the Worse (Using Turn Signals)

Distracted driving is bad, you know that.  Daydreaming, talking on the cell phone, putting your makeup on in the rear view mirror.  All bad.  But there's something else that causes more than twice as many accidents, according to a recent study.  And that's people who don't use their turn signals. 

Maybe you're one of them.  One survey said nearly a quarter of drivers were just too lazy to use their turn signals.  Others said they didn't use them because they weren't really necessary.  Traffic laws may dictate otherwise, but statistics show police don't write that many tickets for turn signal violations. 

You may have encountered the driver who cuts into your lane without signaling a change.  Often, that person does it deliberately to catch you off guard so you won't invade his or her space.  And when it comes to young drivers using turn signals, one insurance company survey showed more than two-thirds of those they talked to admitted it wasn't their regular practice.

Knowing that, you may wonder why you should use your turn signal.  The reason is simple.  It lets other drivers know what you plan to do.  Driving it tricky enough with all the moving parts on the road.  The more you know what other people are doing, the more you can prepare for that with the way you drive.

How many times have you seen someone turn left without putting their turn signal on?  That's a leading cause of rear-end accidents. Not only does using your turn signal promote safety, it also shows courtesy to other drivers.

There are some drivers who don't use turn signals because their turn signals don't work.  What a lousy excuse! All of the safety equipment in your vehicle should be working; if it isn't, head over to your repair facility.  Often it's as simple as a burned out bulb or a broken wire. 

Finally, the number one reported reason for not using a turn signal is that drivers just forget to do it.  (And the ones who DO use their turn signals and forget they're on?  We won't even go there.)

Engineers put turn signals on vehicles for a reason.  They help drivers communicate with other drivers.  Using them could save accidents… and lives.


Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

The Right Oil for the Season (Engine Oil Viscosity)

As the temperatures plunge, certain types of engine oil may not flow as easily as they did when it was warmer.  Makes sense, doesn't it? Just like molasses gets thicker as the temperature goes down, engine oil does the same thing. So, maybe you're wondering if you have to change your oil as the seasons change so it's just the right thickness to lubricate your engine parts. 

How well engine oil flows is called its viscosity. There are different types of oil—some that have just one viscosity and others called "multigrade" oils.  Here's the difference.

A single viscosity oil will flow better when it's hot but not as well when it's cold.  A multigrade oil is engineered so that its flow properties at cold temperatures are different than they are at warm temperatures.  In other words, a multigrade oil can start out in colder temperatures acting like a thinner oil and then behave like a thicker oil when it's warm.  That's a pretty cool trick and it's why multigrade engine oil is used in nearly all vehicles.  Your vehicle's manufacturer has the correct viscosity of oil for your particular model included in the owner's manual.

Another choice you have to make when it comes to engine oil is whether you use conventional oil, synthetic oil or a blend of the two.  Synthetic oils have some advantages over conventional, such as resisting breakdown better and withstanding higher temperatures.

Check with your service advisor to see which viscosity and type of oil is recommended for your vehicle.  It's important that in cold weather, the oil flows through your engine at the right thickness so that parts are being properly lubricated.  That will make sure you'll get good fuel economy and performance, no matter what the temperature is.


Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

No Strain, No Gain (The Basics of Oil Filters)

Ever wonder what one of the best things is to ever happen to your vehicle's engine?  It's the little thing that usually looks like a can, the oil filter.

Just like your kitchen sink strainer filters out errant particles of food from clogging your drain, the oil filter cleans out small particles that could cause your engine harm.

Your engine operates in a dirty, hot environment and gathers a lot of tiny contaminants like dirt, dust, little metal shards and unlucky bugs that get sucked in.  Get those things circulating in your engine and those little particles can cause friction, which starts wearing out those finely machined metal parts. 

You know how important it is to change your oil regularly.  It's vital that you change your oil filter at the same time to keep the oil as close to brand new as possible.

Most oil filters look like a metal can with some holes in the bottom.  Inside there are carefully chosen materials that can screen out the contaminants while at the same time allow the lubricating oil to pass through.  Early oil filters had steel wool, metal mesh or actual screens.  Then they tried fabric filters using material such as linen and cotton.  Finally, a less expensive disposable filter using paper and cellulose did the trick.

Cellulose or other synthetic media are used in most oil filters today.  Cellulose is inexpensive and effective.  Fibers filter out particulates and let the oil flow.  The other synthetic media have the ability to screen out even tinier particles while not significantly restricting the oil from getting through.  Engineers continue to work on even more advanced filter material.

Choosing the right oil filter is something our pros at Camarillo Car Care Center can help you with  because there are a lot of them out there.  Factoring into that decision are your driving habits, how far you drive and the temperatures to which your engine will be subjected.  While some filters will cost more than others, they may be worth it to extend the life of your engine. 

But most important is remembering to come have your oil changed at Camarillo Car Care Center regularly at the intervals recommended by the vehicle's manufacturer. Just like you wouldn't want to have a plumber come over to fix a clogged kitchen drain, you certainly wouldn't want to have to pay for major engine repairs if they could be prevented by regular oil and filter changes.


Camarillo Car Care Center
2739 Daily Drive
Camarillo, CA 93010
805-482-2853
www.camarillocarcare.com

Camarillo Car Care Center is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call Camarillo Car Care Center (805) 482-2853 if you have any issues in accessing any area of our website.